struct_regulation_constraints (9) - Linux Manuals

struct_regulation_constraints: regulator operating constraints.

NAME

struct_regulation_constraints - regulator operating constraints.

SYNOPSIS

struct regulation_constraints {
  const char * name;
  int min_uV;
  int max_uV;
  int uV_offset;
  int min_uA;
  int max_uA;
  int ilim_uA;
  int system_load;
  unsigned int valid_modes_mask;
  unsigned int valid_ops_mask;
  int input_uV;
  struct regulator_state state_disk;
  struct regulator_state state_mem;
  struct regulator_state state_standby;
  suspend_state_t initial_state;
  unsigned int initial_mode;
  unsigned int ramp_delay;
  unsigned int enable_time;
  unsigned int active_discharge;
  unsigned always_on:1;
  unsigned boot_on:1;
  unsigned apply_uV:1;
  unsigned ramp_disable:1;
  unsigned soft_start:1;
  unsigned pull_down:1;
  unsigned over_current_protection:1;
};  

MEMBERS

name

Descriptive name for the constraints, used for display purposes.

min_uV

Smallest voltage consumers may set.

max_uV

Largest voltage consumers may set.

uV_offset

Offset applied to voltages from consumer to compensate for voltage drops.

min_uA

Smallest current consumers may set.

max_uA

Largest current consumers may set.

ilim_uA

Maximum input current.

system_load

Load that isn't captured by any consumer requests.

valid_modes_mask

Mask of modes which may be configured by consumers.

valid_ops_mask

Operations which may be performed by consumers.

input_uV

Input voltage for regulator when supplied by another regulator.

state_disk

State for regulator when system is suspended in disk mode.

state_mem

State for regulator when system is suspended in mem mode.

state_standby

State for regulator when system is suspended in standby mode.

initial_state

Suspend state to set by default.

initial_mode

Mode to set at startup.

ramp_delay

Time to settle down after voltage change (unit: uV/us)

enable_time

Turn-on time of the rails (unit: microseconds)

active_discharge

Enable/disable active discharge. The enum regulator_active_discharge values are used for initialisation.

always_on

Set if the regulator should never be disabled.

boot_on

Set if the regulator is enabled when the system is initially started. If the regulator is not enabled by the hardware or bootloader then it will be enabled when the constraints are applied.

apply_uV

Apply the voltage constraint when initialising.

ramp_disable

Disable ramp delay when initialising or when setting voltage.

soft_start

Enable soft start so that voltage ramps slowly.

pull_down

Enable pull down when regulator is disabled.

over_current_protection

Auto disable on over current event.

DESCRIPTION

This struct describes regulator and board/machine specific constraints.

AUTHORS

Liam Girdwood <lrg [at] slimlogic.co.uk>

Author.

Mark Brown <broonie [at] opensource.wolfsonmicro.com>
Wolfson Microelectronics,

  

Author.

COPYRIGHT