shorewall-notrack (5) - Linux Manuals
shorewall-notrack: shorewall notrack file
NAME
notrack - shorewall notrack file
SYNOPSIS
- /etc/shorewall/notrack
DESCRIPTION
The columns in the file are as follows.
SOURCE - {zone[:interface][:address-list]|COMMENT}
-
where
zone
is the name of a zone,
interface
is an interface to that zone, and
address-list
is a comma-separated list of addresses (may contain exclusion - see
shorewall-exclusion[1]
(5)).
Comments may be attached to Netfilter rules generated from entries in this file through the use of COMMENT lines. These lines begin with the word COMMENT; the remainder of the line is treated as a comment which is attached to subsequent rules until another COMMENT line is found or until the end of the file is reached. To stop adding comments to rules, use a line with only the word COMMENT.
DEST - [interface|address-list]
-
where
interface
is the name of a network interface and
address-list
is a comma-separated list of addresses (may contain exclusion - see
shorewall-exclusion[1]
(5)). If an interface is given:
- *It must be up and configured with an IPv4 address when Shorewall is started or restarted.
- *All routes out of the interface must be configured when Shorewall is started or restarted.
- *Default routes out of the interface will result in a warning message and will be ignored.
- These restrictions are because Netfilter doesn't support NOTRACK rules that specify a destination interface (these rules are applied before packets are routed and hence the destination interface is unknown). Shorewall uses the routes out of the interface to replace the interface with an address list corresponding to the networks routed out of the named interface.
PROTO - protocol-name-or-number
- A protocol name from /etc/protocols or a protocol number.
DEST PORT(S) - port-number/service-name-list
- A comma-separated list of port numbers and/or service names from /etc/services. May also include port ranges of the form low-port:high-port if your kernel and iptables include port range support.
SOURCE PORT(S) - port-number/service-name-list
- A comma-separated list of port numbers and/or service names from /etc/services. May also include port ranges of the form low-port:high-port if your kernel and iptables include port range support.
USER/GROUP - [user][:group]
- May only be specified if the SOURCE zone is $FW. Specifies the effective user id and or group id of the process sending the traffic.
FILES
NOTES
- 1.
-
shorewall-exclusion
- shorewall-exclusion.html
SEE ALSO
shorewall(8), shorewall-accounting(5), shorewall-actions(5), shorewall-blacklist(5), shorewall-hosts(5), shorewall-interfaces(5), shorewall-ipsec(5), shorewall-masq(5), shorewall-nat(5), shorewall-netmap(5), shorewall-params(5), shorewall-policy(5), shorewall-providers(5), shorewall-proxyarp(5), shorewall-route_rules(5), shorewall-routestopped(5), shorewall-rules(5), shorewall.conf(5), shorewall-tcclasses(5), shorewall-tcdevices(5), shorewall-tcrules(5), shorewall-tos(5), shorewall-tunnels(5), shorewall-zones(5)