g_gmxcheck_d (1) - Linux Manuals

g_gmxcheck_d: checks and compares files

NAME

gmxcheck - checks and compares files

VERSION 4.0.1

SYNOPSIS

gmxcheck -f traj.xtc -f2 traj.xtc -s1 top1.tpr -s2 top2.tpr -c topol.tpr -e ener.edr -e2 ener2.edr -n index.ndx -m doc.tex -[no]h -nice int -vdwfac real -bonlo real -bonhi real -tol real -[no]ab -lastener string

DESCRIPTION

gmxcheck reads a trajectory ( .trj, .trr or .xtc), an energy file ( .ene or .edr) or an index file ( .ndx) and prints out useful information about them.

Option -c checks for presence of coordinates, velocities and box in the file, for close contacts (smaller than -vdwfac and not bonded, i.e. not between -bonlo and -bonhi, all relative to the sum of both Van der Waals radii) and atoms outside the box (these may occur often and are no problem). If velocities are present, an estimated temperature will be calculated from them.

If an index file is given it's contents will be sumamrized.

If both a trajectory and a tpr file are given (with -s1) the program will check whether the bond lengths defined in the tpr file are indeed correct in the trajectory. If not you may have non-matching files due to e.g. deshuffling or due to problems with virtual sites. With these flags, gmxcheck provides a quick check for such problems.

The program can compare run two input ( .tpr, .tpb or .tpa) files when both -s1 and -s2 are supplied. Similarly a pair of trajectory files can be compared (using the -f2 option), or a pair of energy files (using the -e2 option).

For free energy simulations the A and B state topology from one run input file can be compared with options -s1 and -ab.

In case the -m flag is given a LaTeX file will be written consisting a rough outline for a methods section for a paper.

FILES

-f traj.xtc Input, Opt.
 Trajectory: xtc trr trj gro g96 pdb cpt 

-f2 traj.xtc Input, Opt.
 Trajectory: xtc trr trj gro g96 pdb cpt 

-s1 top1.tpr Input, Opt.
 Run input file: tpr tpb tpa 

-s2 top2.tpr Input, Opt.
 Run input file: tpr tpb tpa 

-c topol.tpr Input, Opt.
 Structure+mass(db): tpr tpb tpa gro g96 pdb 

-e ener.edr Input, Opt.
 Energy file: edr ene 

-e2 ener2.edr Input, Opt.
 Energy file: edr ene 

-n index.ndx Input, Opt.
 Index file 

-m doc.tex Output, Opt.
 LaTeX file 

OTHER OPTIONS

-[no]hno
 Print help info and quit

-nice int 0
 Set the nicelevel

-vdwfac real 0.8
 Fraction of sum of VdW radii used as warning cutoff

-bonlo real 0.4
 Min. fract. of sum of VdW radii for bonded atoms

-bonhi real 0.7
 Max. fract. of sum of VdW radii for bonded atoms

-tol real 0.001
 Relative tolerance for comparing real values defined as 2*(a-b)/(|a|+|b|)

-[no]abno
 Compare the A and B topology from one file

-lastener string
 Last energy term to compare (if not given all are tested). It makes sense to go up until the Pressure.